CAMO 345005 Guia de Instalação descarregar pdf

Hidden Deck Fastening System

Installation Instructions – CAMO™ Marksman™

With the CAMO HIDDEN DECK FASTENING SYSTEM (CAMO System), you create a beautiful, fastener-free deck surface using

any treated wood, hardwood, cedar, composite or PVC deck board.

The CAMO Marksman is used to guide the CAMO screw into the side of the deck board into the joist. It can be used on any

nominal 1” x 6” solid deck board. No pre-drilling is necessary, and the Marksman provides automatic 3/16” spacing between deck

boards.

Before beginning installation of your deck, you will need the following:

– CAMO Hidden Fasteners

– CAMO Driver Bit (included with CAMO Hidden Fasteners)

– CAMO Marksman Tool

– Drill (set drill speed to highest setting for maximum driving efficiency)

– Optional: “L brackets” or 2-1/2” x #7 Pro-Fit

Platinum Series Trimhead Screws (for starter board)

CAMO MARKSMAN SCHEMATIC:

Starter board:

To begin deck installation, lay your first deck board (the starter board) in position. If the starter board runs parallel to the house or

other structure, it may be necessary to face fasten the board (see options below). If so, we recommend using 2 ½” Pro-Fit

Platinum Series premium trim head screws.

TIP: You can secure the starter board in several ways:

(1) face fasten the first board or board and a half

(2) face fasten only the edge adjacent to the house/structure - to do this, lay out the location for the CAMO fasteners that will

be driven TOWARD the house/structure; with the Marksman tool in place on one end of the starter board, squeeze the Tool

Trigger and maintain slight downward pressure on the Tool Handle. Load one CAMO screw into the screw guide. No pre-

drilling is necessary. Prestart the screw about ½ inch into the board; release the Trigger Handle to remove the Marksman;

continue the length of the board; position the deck board with the pre-started screws on the outside edge; with the board snug

to the house/structure, finish driving the CAMO screws. Finish the board by face fastening the inside edge of the board

(3) avoid face fastening by using “L brackets” to fasten the starter board from below the deck to the joists.

Once you have secured the starter board, proceed with installing the remainder of the deck boards using the CAMO System.

1 2

Hidden Deck Fastening System Installation Instructions – CAMO™ Marksman™ With the CAMO HIDDEN DECK FASTENING SYSTEM (CAMO System), you create a be

Hidden Deck Fastening System Installation Instructions – CAMO™ Marksman™ set Beginning on one end of the deck board, set the CAMO Marksman tool o

Sem comentários

CAMO 345005 Guia de Instalação